This is an angle grinder holder for the DDD Wall Control System.

I based the measurements on my Bosch GWS8-45, which has a guard diameter of 130mm. The front of the holder is 3mm thick. It should fit other 4 ½" angle grinders as well, although I haven't tested others. Check measurements before printing.

The front edge is just thin enough to slide behind the blade guard. It keeps the angle grinder upright with no additional supporting pieces.

There is sufficient clearance behind the angle grinder to hang extra wheels or accessories on a 2 inch quick hook. See picture.

Recipe

Here are the other parts I used from DDD Wall Control:

• 2x2 Angle Bracket Flat Left
• 2x2 Angle Bracket Flat Right
• 4x10x8mm Pin (x4)

Square brackets should work as well. L brackets should probably be avoided as they are intended for lightweight loads.