I noticed that the remix source introduced roll in the sensors if you angled them, as the mount itself has a slightly incline. With the sensors having a rectangular perspective, this means you lose a little bit of tracking area near the floor.

I designed it from scratch (mostly for fun), with the main difference being that there is no incline in the snap fit. I also added a hole for fitting in a small zip-tie just to keep it a bit more secure.

No

No

0.3mm

15%

Print top-side down (i.e., the way that will require no supports).

Push the cable and the sensor rod thingie into the mount together. The rod being pushed in will also push the cable in. Haven't tried to take it back out again yet but you can probably lever it!

Stick it on your wall with a medium 3M command strip. You can mount it right way up or upside down. My preference is upside down as it has a bigger tilt range this way.