This is a fan shroud for the Nvidia Tesla K80 GPU. The Tesla K80 was designed for server use, so it lacks a integrated cooling fan (relying on the forced air of the server)

This model expects an 80mm fan (low profile!) to be screwed to the front, (intake air from case, blow out the duct) and the unit attached to the card via double-sided tape (or via two well placed self-tapping screws "inside" the fan area into the plastic case (not the transparent plastic) of the K80)

Print with thick walls for stability, and carefully clean out the support structure after printing.

Reminder: The Tesla K80 can be equipped with a standard PCIe power cable OR a 8PIN EPS (CPU) power connector. These are not compatible with each other, and damage may occur if you try to power it with the wrong cable pinout!

Ultimaker

Ultimaker 2

No

Yes

30