This is a wall mount for the Samurai Mask Model 3 that can be found here (original) and here (remixed). The wall mount itself is two main parts with an optional third stabilizer that can be fastened with a little super glue. It is designed with Command strips in mind (glue, tape or other fastening means may be used depending on your wall modification abilities)

Models are meant to be printed with as few/no supports. The only model that might need them is the nose mount, to make sure the half circle doesn't collapse. It's probably able to be printed without, but every printer's limits are different.

All models print as-downloaded. The model in photos does not have the stabilization plate. If plate is used, recommend printing two, for the top and bottom, so the wall contact surfaces will still be the same height and the angle of attachment remains the same.

Settings used for print in photos:
Perimeters: 2
Layer Height: .15mm 
Infill: 10%
Supports: Build plate only
Support Style: Organic

Big thanks to @KuromanKuro_1054244 for letting me know how wonky the models were so I could fix them!