This is a wheel guide you can attach to your weed eater (whacker, trimmer) to make it easy for you to trim the edges of your lawn where it meets the sidewalk.

This should work on most trimmers that have about a 1 (or 3/4) inch diameter pipe.

It is very lightweight. The bearing accounts for almost half the weight.

Print instructions

Unassociated tags: Weed Eater

Category: Tools How to Make this thing?

Materials Needed:

1x of each of the printed parts.
3x Dry wall screws. (1.25 to 1.5 inches long)
1x 608 bearing. (Shielded recommended but you could use unshielded from an old fidget spinner)

Print Settings Layer height = .2 mm
Supports = No
Raft = Doesn't matter
Filament = PETG reccomended
Perimeters = 6 (make the walls about 3 mm thick)
Infill = 30 %

All required parts

How to assemble

Assembled and attached

If you like this design...

... please click the like button.

Thank You