Filament Runout Sensor Box
Slow Fawn
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
1
0
Publicado:2026-01-17 07:36:10
0
0
010Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
A box to house the Z stop circuit board to be re used as a filament runout sensor. this is only a guide component. Since there are a multitude of modifications to include extruder guides, spool holder mounting locations, and filament guides this is only the bare minimum to get you started modeling up a design to be used for your specific setup.
This design utilizes and houses the z stop circuit board, micro switch, and mounting screws. I designed 7 different models before arriving at this one. I would highly recommend doing 100% infill to ensure the screw mounting holes are secure.
You will also have to rewire the XHP-3 JST connector to be able to reach the mainboard
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.12
Infill:
100%
Filament: Your Choice I used PLA Your Choice
Notes:
I used Cura 4.7.1 with ultimate settings, ironing off and combing on.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY