This is a remix of this file:

Flexible flat cable holder Ender 3 S1 Pro by ExpertBG - Thingiverse

This bracket holds the extruder/x axis cable in place as it goes up and down the Z Axis.  I found the original to work extremely well for my Ender 3 S1 Pro, and when I got the SV07 Plus, I wanted something similar.  The SV07 Plus being so new, there were not many upgrades/mods available, so I remixed the original to work with the Plus.  It may work with the regular SV07, but I am not sure.

Photos show print in PLA.  Printed one in PETG and it came out just as good.

There is no need to remove any hardware from the printer, just work the bracket into place. The right-side upper arm should just 'click' into place over the gantry bracket when it is position.  

My support settings are not quite dialed in yet, so I had to do a little scraping for the bracket to 'click' into place, mainly around the little vertical tab on the front of the piece.  

Supports are required.

30% Infill