My wife asked me to make a wall mount for equestrian whips to install into our horsebox. This is what I came up with. It seems plenty strong enough in PLA and grips the whips well. This one will accommodate up to six whips (I've no idea why one would need more than one, but there you go!)

There are two versions: one which can be stuck up with adhesive pads or a chunkier one with screw mounting holes.

I'll upload the photos of the finished prints soon

Print on its side and it needs no supports or brim etc

FlashForge

Creator Pro

No

No

0.2

30%

Needs no supports and prints quite quickly. Just check that your slicer doesn't leave any gaps in the actual "clip springs"