Pony and fox hugging.

I used (but edited) the following models:

• https://www.thingiverse.com/thing:2843957
• https://ponysfm.com/augmented-enhanced-pony-models

No supports required. No infill required. However, if printing at full scale, infill is recommended anyway to prevent warping.

Fox ears match each other by height. This prevents melting at the end of the print.

This on DeviantArt: https://www.deviantart.com/mraagh/art/3D-Sorunome-and-Pixel-807172113
This on my website: http://mazie.rocks/main.html#sorupixel

Creality

Ender 3

No

No

0.06 mm

No

I had problems without infill. I recommend a little bit of infill anyway. Maybe 5% - 10%

Post printing (what I did):

• sanding, washing and priming (3 times)

• painting with brush and acrylic paint (3 coats)