# Print Settings

Printer Brand/model : Creality Ender 3 V2 Neo

Rafts : No
Supports : No 
Resolution : 0.26+
Infill : 15%+ 
Filament: Any PETG/PLA

Notes : 

Quite an easy print and easy on the eyes too, but that comes with some caveats :
there's nothing customizable (angle/wood/etc). So print it at your convenience, but keep that in mind and know your measures.

Some recommandations now :

• I highly recommand going for the compact profile (pedalboard_v1.d-profile.compact).

The small/big profiles are indeed a more bulky/solid approach with a nice gap between the wooden planks but there are not that optimized (but I've printed the big profile without any issue though, just to be sure)

• wooden planks :

1.5 cm height / 7 cm large / lenght < 60 cm ( ≈ 0.59 inches / ≈ 2.76 inches / length < ≈ 24)

I don't recommand lenght higher than 60 cm but this should work if you're considering some heavy/solid wood types (e.g : oak). Most wood types will work but chipboard wood is a NO GO. The screws on the profile front and back will screw that up... for sure.

Infill and resolution are not that important here. I used 15% and I'm pretty sure I could have tried 10% without any issue. Same for resolution : the fastest you can go is probably the way to go, so higher resolutions should be welcome. Let me know what worked for you in the comments.

Note 1 :

I used 2 wooden planks with a lenght around 29cm in the photos and honestly... it's a bit short (but these were the nicest planks I had). This is still suitable for me since it was specifically designed for the mod dwarf pedal. You might consider at least 40 cm.

Note 2 :

there are several ways to get any lenght you want. For example, by printing a third profile and assemble the wooden planks at the center (I did it for the fun of it) but I will let you think about it yourself about how to do that.

Category: Music