Compatible with the Yootech Qi wireless charger.

I got tired of my phone pausing while charging because it wasn't perfectly aligned on the wireless charger, so I've been developing this stand to allow you to just set the phone in the stand in the exact position in which it needs to sit.

It positions your phone in at an ergonomic angle for viewing the time and everything too.

The Yootech Qi charger can be found at: http://www.amazon.com/Yootech%C2%AE-Wireless-Charging-Blackberry-Qi-Enabled/dp/B00NWMI07S/ref=sr_1_1?s=wireless&ie=UTF8&qid=1436553331&sr=1-1&keywords=wireless+charger

No support material needed.

It's designed to fit withing the 90mm x 90 mm x 90 mm print volume of a Q3D OneUp printer if a close skirt is used (~0.5 mm).

I printed it with PLA at 20% rectilinear infill.

Print in its upright position, so the bottom is face down; just rotate it 90 degrees about the x-axis on your slicer software, and that should orient it properly for printing