please be informed of if this is good for you. this guy explains that z axis stabilizers
may not help, but rather hinder your performance. however there are situations where these are needed. https://www.youtube.com/watch?v=2Z7mZVvPlc8&t=176s

based off of this design. https://a.aliexpress.com/_mPIgrxF

That link has a video that shows it's y axis adjustability, but I also increased some tolerances for the top screws to allow for some minor x Axis adjustment.

hardware needed:

4x m3x20mm
2x m3 tnuts
2x m3 nuts
1x 608zz skateboard bearing

depending on your screws it may require washers on the 2 top screws. (i have included some washers in the event you dont have any)

no supports needed.

Prusa

Mk2.5s

Doesn't Matter

Doesn't Matter

0.2

40%

n/a

reverse engineered the design in the aliexpress link above