A movie theater in your pocket.

I got this Microvison laser projector from Woot years ago, but didn't use it much. To make it more useful I made a custom bracket to hold it and the 30pin iPhone that drives it on a tripod mount.

Monoprice Mini select

No

No

Layer height: 0.1 Shell thickness: 0.8

20%

Printed in PLA
Print temp: 200°

I took some measurements with a digital calipers and built it up in OpenSCAD. I used a fudge factor when differencing polyhedron to avoid zero-width faces/

The space for the tripod nut was too tight for me to get the nut in by hand, but I could easily press it in by firm pressure on the nut with a hot soldering iron. But, then it fell right out again. A little superglue holds the nut in nice and firm.

Although the projector looks a bit dim in the photo, it's nice and visible in a darkened room.

I started with http://www.thingiverse.com/thing:40703