About a 4-inch sphere featuring delivery robots from my college campus and a pair of trees. I found that the pedestal and the robots made great faces to put names and the year on. It took a bit to make the flags strong enough to print and survive the support removal process. It was a really fun project to make especially with putting names and the year on it to personalize it. I included some pictures of one that I personalized for my roommates as an example of customization.

Creality

Ender 3 Pro

Yes

Yes

0.16

25%

If you can do conical supports or something similar I highly recommend it, this will cut print time and material down significantly as well as make your life easier when you remove the supports.

Be careful with the supports near the flags and take your time when removing them. The supports around the bottom of the trees can also be a bit of a bear. Other than that it wasn't too bad when using the conical supports in Cura.