This thing is a fairly simple camera mount to get a Logitech C-270 to sit on the bed of a Qidi Tech X-One for recording/streaming prints. I built this model from scratch after my iPhone idea failed.

This keeps the camera aimed right at the middle of the bed and gets a good amount of the build area in each shot. Not bad for a $20 camera and 1.5 hours of printing.

The C-270 has to be disassembled from its included monitor mount to fit, but the peg and screw from that fit perfectly into this model to secure it. You may also need to take the camera apart to manually dial in the focus as it comes locked for a longer shot.

I recommend printing in ABS or PETG to avoid it warping under the heat the bed puts out.

Version 2 allows you to mount on the side or the front. Front mounting will cause it to stick out of the enclosure.

Qidi Tech X-One

No

Yes