This design is a case to house an Allstar AURSINC Shari PiHat radio and a Raspberry Pi model 4 computer board. The Raspberry Pi board sits vertically at the bottom with the AURSINC Shari PiHat radio on top. The power cord is plugged in on the lower left side directly into the raspberry Pi. The power cube that you use to run the node should supply a clean 5Volts with at least 2 amps of current. The case provides cooling by convection through holes on the back side. There is an access port to get at the SD card in the bottom side. Print the case standing up and no supports are needed. I made no provision to secure the Raspberry Pi and the radio in the case. the only thing holding it in is gravity.

Prusa

I3 MK3S

No

Doesn't Matter

.2 is fine enough

20%