Great looking phone stand, designed for iPhone 12 Pro Max with fat case, it has 14 mm space between back and front. If you would like 12 mm or even 10 mm version comment it and i can make it. Just measure how fat is your phone with case if you are using one.

It prints without supports in PLA standing as it is but if you would like to use them then add just below overhang on the bottom of the plate.

Looks great in Silk filament.

I've printed it in 0.15 mm layer height, but you can also use 0.2 without problems. You can try with 0.25 or more but overhangs could be worse.

It takes about 8 hours with 0.15 mm layer height on Prusa MK3S

Prusa

I3 MK3S

No

No

0.15 mm

10-20%

No supports, prints as it stands on the build plate