This Monster fish is an articulated model that does not require supports, the model is inspired by the fascinating creature of the depths “Chauliodus sloani” whose mouth and teeth are disproportionately large with respect to its body.

The model is made up of a single piece, however there are two files: "02 Appendix" and "03 Eyes" are a complement and I recommend printing them on fluorescent material.
At the base of the skull there is a hole designed to insert a piece of filament, at the other end is the appendix. These pieces must be attached with glue so that they are completely attached to the body.

As it is a model with a lot of small little pieces, I recommend making sure of:

To have activated the thin walls option.

To have a good adhesion to the hot bed.

To have the retractions well calibrated

General printing settings

-Wall Line count : 3

-Top and Bottom layers: 3

-Printing time : 11h06min

-Total material : 69g

If you like our models check out here :

https://cults3d.com/en/users/MadiStudios/creations
https://www.patreon.com/Madistudios

Enjoy printing!

No

No

0.2

15