Summary

I didn't like the filament 'strain' portion. It was causing tension, and making a lot of noise while the filament was feeding in. I also added the VYPER lettering to the sides.

HW I'm using to mount this:

• 2x M3 16mm bolts for the base
• 2x M3 20mm bolts (sensor housing)
• 2x M3 nuts (sensor housing)

Printed on Anycubic Vyper, with PrusaSlicer, using Creality CR6-SE profile with modified bed size.

205C extruder temp, 60C bed temp
0.2mm layer height
3 perimeters
seam position aligned
external perimeters first
avoid crossing perimeters
skirt height 1
Increased XYZE Jerk Values by about 80%
Retraction set to 3mm, 40mm/s, 0.8mm min distance