Android Driedel.
I took the Droidel by mishugana, cut it in half, and added a handle.

Unfortunately it doesn't spin very well. It may work better if you give the body a higher infill.

Print the head, body, and stem, then super glue them together with the round part of the stem sticking out the top.

I split the head and body into separate parts so they could be printed flat side down. I printed both with supports because the head has a small lip that needs supporting and the letters on the body are raised.

I printed the head and body at 10% infill, but I think the body is too light. I suggest a high infill for the body and some extra shells for good measure.

The stem needs just a little sanding to fit into the square hole. I made the hole in the body too deep, so you should glue the stem at the desired height in the head before gluing that onto the body.