So this is my first upload of a design to thingiverse:

I'd like to mention that the throttle handle is from Akaki Kuumeri the designer of the Xbox joystick, and I'd like to mention them.
This design is meant for the Saitek Cyborg 2000 joystick model, and is a throttle extension handle.

Bambu Lab Carbon X1C

Doesn't Matter

Yes

0.012 mm

50%

• Use 100% infill for throttle handle if you want to feel the weight of it, otherwise not needed.
  Support is recommended, I used tree support but any is fine.

After finished printing:

1. Unscrew the bolt for the mini throttle caps, with an allen key
2. Put on the cylindrical part, and put the screw in from the other end (tighten to your preference)
3. put the support base on the other end(You may want to put tape of some sort of grippy rubber on the bottom to add height and to keep in place)
4. Put the handle on the rectangular bar, and insert into the fitted slot on the cylinder.