Tip out tray for hinged sink door storage.

6/15/15: Added Larger version

Small version is: 7" wide, 2" standout from door, and 2.75" high.
Large version is: 8.75" wide, 2: stand out from door, and 3.25 high.

If you want a tip-out tray and have plastic to burn, these are nice ones. Most tip out sink doors will support two of these side by side. I'm thinking instead of using 4 screws, I'll super glue the joining sides and glue a plastic bar across the bottom, which effectively makes it one piece with a divider in the middle. Plus only need 2 screws this way.

NOTE: I designed this from a solid block, from which material was removed. Also note that the large version still shows holes in the back. I left the pattern but closed the holes so moisture wouldn't get on the mounted surface.

The large tray didn't update, so I made a v2 for no holes in the back. Left the other one just in case someone prefers the holes.

My first print was ABS, but it pulled up from glass some, maybe the print bed wasn't hot enough, but I'll try PLA on the next one.

The larger tray pushes the limits of the Flashforge Creator. I printed the first couple layers and it will do fine.