This is to mount some OEM style switched in place of the left ash tray on a Discovery 2.
I am using them to run lights and a winch from inside the cab.

I designed this to fit the standard Disco switches that are used for the hill descent control, hazards, fuel door, central locking switch, etc to keep an OEM look. You could order these switches new online, but I found mine from a part out vehicle for a couple bucks. They look a lot nicer than the gimmicky light up switches you can find on online retailers.

Will require a little bit of trimming of the ash tray housing, as shown in the pictures, to accommodate the back of the switches.

Doesn't Matter

No

20

Print on front face. The support for the locking tab is modelled and is easy to remove after the print