BUNNY EGG
Edward Ellison
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-08-22 10:22:17
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
Layers (Layer Height): 0.2 mm for a balance between details and printing speed. Print Temperature: 200-220 °C, optimized for PLA material. Bed Temperature: 50 °C for better adhesion of the model to the bed. Print Speed: 50 mm/s for stable and quality printing. Infill: 15-20% for sufficient model strength. Supports: Use supports only where absolutely necessary, such as under recesses or protrusions. Cooling: Enable cooling to minimize deformations during the printing of smaller details. Ensure that these values are adjusted to your 3D printer specifications and make adjustments as needed.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC BY