PPK Prop

I just took an old model that was in 2 halves and remixed it.

Reduced the file sizes in Meshmixer.
Put the 2 halves together.
Re-scaled the whole model to approximate actual size.
Cut out the extra filler behind the trigger and reshaped it a bit.
Hollowed out the barrel (.32 cal).
Cut out the hammer path.
Added the notch in the rear site.

It is not a replica as there are still issues with the rear of the slide among other things, but it is closer.

I added a post to elevate the model 5mm off the build plate to help min deformities. For some reason Cura would not slice it if not touching the plate when using tree supports and adaptive layers.