A 'universal' wallmount screwdriverrack. Holds 21 screwdrivers.
Print at 100% for your average screwdrivers - 120% or larger for those few really big ones (if your print bed is large enough).
spacing between the holes at 100% is 2.5cm (so handles up to 5cm in diameter fit).

For best results, lay it top down in your slicing software since that's the biggest flat area.

I had some underextrusion at the end (you can see it in the final pictures), because my spool decided to leave the table mid-print.

This is my first design, so any constructive criticism is welcomed!

Also see the remixed version with better wall clearance