This is a laptop stand I made to hold my Macbook Pro and reduce the amount of space it takes up on my desk. It's intended to operate in clamshell mode with external monitors and accessories.

The distance between prongs is 17mm wide. I designed this to be a snug fit for my laptop, which is a feature that I like but is not strictly necessary for use. You can easily scale it in your slicer to change that distance if you wanted to.

Slicer settings:

• Layer height: 2mm
• Infill: 20%
• Support material: no

Print time was about 8 hours for me. The model is 190mm (~7.5) inches long.