QUIET TUNE – PRINTING INSTRUCTIONS

Thank you for downloading/purchasing this model.

This file contains the recommended printing, safety, and basic troubleshooting instructions for the Quiet Tune flute model.

--------------------------------------------------

1. SUPPORTED USE

--------------------------------------------------

This is a 3D printable wind instrument model intended to be printed as provided in the included model files.

If a .3mf file is included, it contains the recommended print setup and should work directly in compatible slicers such as Bambu Studio.

--------------------------------------------------

2. RECOMMENDED PRINT SETTINGS

--------------------------------------------------

Material:

- PLA or PETG only recommended

Printer / Slicer Notes:

- 0.2 mm layer height

- 0.4 mm nozzle

- No supports required

- PEI plate recommended for best adhesion

- Place the finger holes on the build plate

Optional:

- Use variable layer height on the mouthpiece area for a smoother finish where it touches the lips

Additional Note:

- If using a plate other than PEI and warping becomes an issue, use a brim

--------------------------------------------------

3. IMPORTANT PRINT ORIENTATION

--------------------------------------------------

- Print with the finger holes facing the build plate

- Do not reorient the model unless you understand how it may affect airflow and sound quality

--------------------------------------------------

4. WIND INSTRUMENT PRINTING NOTE

--------------------------------------------------

3D printing wind instruments can be sensitive to even very small imperfections.

The most critical areas are:

- The sound hole

- The internal windway / air channel

For proper sound production, these areas must print cleanly and remain smooth and unobstructed.

--------------------------------------------------

5. TROUBLESHOOTING

--------------------------------------------------

Problem:

- Flute produces no sound

- Sound is weak, airy, or unclear

Possible cause:

- Small print imperfections, stringing, or debris inside the windway

How to check:

- Hold the mouthpiece toward a bright light

- Look directly through the windway channel

- Check for blockages, roughness, or stray material

How to fix:

- Carefully remove stringing or debris

- Use a fine needle file, folded fine-grit sandpaper, or a very thin craft knife

Important:

- Be very gentle

- Only remove printing defects

- Do not alter the intended geometry of the windway

--------------------------------------------------

6. SAFETY INFORMATION

--------------------------------------------------

Recommended materials:

- High-quality PLA

- High-quality PETG

Notes:

- Material safety can vary by manufacturer and color

- Wash the mouthpiece after use

- If shared, clean thoroughly with soapy water

- Bacteria can accumulate between layer lines

Warning:

- Do not use hot water

- Do not use a dishwasher

- Heat may warp the printed part permanently

--------------------------------------------------

7. CARE

--------------------------------------------------

- Clean with mild soapy water only

- Dry fully before storage

- Avoid leaving the print in hot environments such as inside a car

--------------------------------------------------

8. FILE USAGE

--------------------------------------------------

Included files may contain:

- Pre-configured .3mf print setup

- Readme / instruction reference

If using another slicer, transfer the settings above manually.

--------------------------------------------------

9. CONTACT / SUPPORT

--------------------------------------------------

If you have questions or issues with the print, please contact the creator/seller.

Email:

contact@teletunes.shop