Remix of billiamthesecond's model. As he hinted at, his model may not work with thicker pegboards, and that was indeed the case for the pegboards on my Seville Classics workbenches because the pegs didn't fit. I also found the holes for the drivers to be a tad too large. So I replaced the pegs with ones I use in my own models of pegboard components and made the holes smaller. I also made the lettering a bit deeper to make it more readable.

This should fit any standard 1'' inch pegboard but then again, thickness and hole size can vary quite a bit between brands.

Technically I guess this model is not a remix but a re-implementation as I started from scratch in Fusion 360. But credit where credit is due, as of course the inspiration for it came from Billiam's model.