another try on making a hueforge

didn t had all the right colors but came out pretty well i think

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x199.72mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA BambuLab Matte Charcoal Transmission Distance: 0.4
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA PolyLite Grey Transmission Distance: 1
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Charcoal
    At layer #8 (0.72mm) swap to Blue Gray
    At layer #11 (0.96mm) swap to Grey
    At layer #20 (1.68mm) swap to Jade White for the rest.