Roborock Adapter H6, 31.5 outer
whaleburg03
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-08-07 19:07:34
0
0
000Descripción
Fuente del modelo
Comentarios(0)
- Based on the author's adapter, I made an adapter for attachments from another vacuum cleaner, so as not to dirty the original attachment when you need to clean something dirty or outside.
- Adapter has a screw-on "tip" with a transition from 31.5 mm to 32.1 mm. (Due to plastic shrinkage, the actual dimensions are 0.1-0.3 mm smaller for my PETG, which was intended.)
- I have a Roborock H60, I don’t know if it’s because of the difference in versions of the vacuum cleaner, but the latch was actually 1 millimeter (or less) out of the groove, but after trimming it a little, it latched properly. Also, this adapter is 1 mm shorter than the original one, I assume there will be a gap of 1 millimeter to the gasket in the vacuum tube and it is possible that dust will accumulate there (this can be solved by simply increasing the length with an additional gasket)
- Theoretically it is possible to cut to the thread and glue any other geometry in any cad
Fuente del modelo
Enlace original: Ver detalles
CC BY-SA