Gear rack for spirograph
StripedPod5
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2025-11-06 15:44:34
0
0
000Descripción
Fuente del modelo
Comentarios(0)
This gear rack is made for 3mm gears from Wild Gears or Spirograph. Most generic or novelty sets should also work, even some 3D printed gears. The gap is 4mm with a 2mm divider and the racks are just over 6 inches long. The rack could be used for storage on smaller gears. On larger gears, it could be used to stage gears for a project, so that you can pull the gears you need ahead of time and stack them smallest to largest. Use one rack for unused project gears and another rack for used project gears. This should reduce the confusion over which gear have and have not been used.
Fuente del modelo
Enlace original: Ver detalles
CC BY