Hope you enjoy and don't forget to check out my page

 for other coasters and neat things to build.

 This is a cup coaster I made for around the house.

 for the 2 colors i paused the print right after the finel slow pass was done of the serface of where the emblem will be

 for the emblem color and paused again after the finel slow pass of the emblem to finsh the print out in.

  I used standard pla the tip temp was 200c and the plate temp was 60c.

 No assembly necessary but what i added was sticky felt pads to bottom of print so not to harm any surfaces.