This is a removable mounting bracket for Clip-on cable organizers. It works with typical cable organizers as shown in the pictures as long as their diameter is less than 22 mm.

The cable organizers can be stuck on to the 3D printed bracket and then the entire assembly can be mounted to the wall with a couple of push pins.

I primarily created it because I have desks that are Black in color, but the organizers are White. I didn't want to stick White clips on a Black desk, and I'm currently in the process of reorganizing my office, but still wanted some quick and movable cable management system in place.

Therefore, this design gives me the ability to set up something quickly and then move it if I want to.

That said, if you want to mount it permanently to the wall, then a couple of small screws can be used in place of the push pins. But these mounting holes were meant for use with push pins and you've to be careful not to select very large screws.

This item was designed in Fusion 360 (Personal).

Creality

CR-10

0.2 mm

15

I prefer that you raft the print. It's longer than it's wider. As a result, it may warp as it cools especially on an open bed printer such as the Creality CR-10.