RainDrip R675CT Bracket
bigflange17
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2025-12-01 08:21:11
0
0
000Descripción
Fuente del modelo
Comentarios(0)
Summary
Well it is spring and I'm working in the yard. Have a RainDrip automatic watering system and was not thrilled with just leaving it on the ground, so I made this to mount it up and off the ground. Easier to see, set/reset, etc. PLA essentially softens too much in the sun here, so I had to make a replacement out of PETG and it is working fine with temps close to 100F here...
Print Settings
Printer Brand:
Bambu Lab
Printer:
Bambu P1S
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
50%
Filament Material:
PETG
Fuente del modelo
Enlace original: Ver detalles
CC BY-SA