Project: nicola.hfp

Print with a 100% infill rate, a layer height of 0.08 mm, and a base layer of 0.16 mm

The model size is 200x200mm.

You can print with a higher layer height at a minimum depth of less than 0.24mm.

The maximum depth is 2mm, and the actual depth is 2mm.

Consumables used:

BambuLab basic black PLA, with a transmission distance of 0.6 meters.

BambuLab basic red PLA, with a transmission distance of 4 meters

BambuLab matte sea blue PLA, with a transmission distance of 0.5

BambuLab basic jade white PLA, with a transmission distance of 5 meters.

This print uses four different consumables

Switching command:

It all started with black

Switch to red on the 13th layer

Switch to sea blue on the 16th layer

On the 18th layer