RIB visor clip. with lock provision
TundraCrew01
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2023-03-24 02:34:49
0
0
000Descripción
Fuente del modelo
Comentarios(0)
Summary
I was not able to search for a garage door clip for RIB type remotes. so I designed my own.
It's pretty rough but it gets the job done.
new version done on Onshape fillet corners
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
No
Infill:
Grid 15%
Notes:
I did this for fun. it depends on your areas climate but so far these are holding up quite ok with My locations 35 celcius afternoons. but I think under direct sunlight these will melt. so use with caution
Fuente del modelo
Enlace original: Ver detalles
CC BY