Introduction

Pipe brackets suitable for MPCNC buildings with a pipe diameter of more than 25mm
It allows adjusting the height to around 30mm.
In addition to the printed parts, you also need an M8 lock nut and an M8 screw

There is a small hole at the bottom... If you put a small screw on the base, the knob can be used to center it, so it won't slip sideways when rotating

Print settings

Printers brands:

Creality

Printing device: Ender 5

Base:

None

Support: None

Resolution:

0.2

Filling: 20%

Consumables:Prusament PC
Gray note: Any material is acceptable.

Fuente del modelo

Enlace original: Ver detalles

CC BY

Introduction

Print settings

Fuente del modelo

Recomendaciones relacionadas