Are you tired of having to look at that Ugly ERCF? That same ERCF that has now cost you 100's of hours of tuning? Look no further! Now you can hide it on the back of your printer never to be seen again! 

This set up fits:

ERCF v2 with 12 gates

NEMA 17 stepper motor

still allows you to open the selector and work on the ercf if you need to 

two 510mm wide 2020 extrusions with tapped holes on either end for an m5 

also, will protect your cable chain on the rear of the ERCF and seems to be helpful if you have some re-winders on the table behind your printer too

I made these obviously to fit a 350mm bed plate, i don't think they will print on much else