This is a mount for the antenna unit of Ring Mailbox Sensor.

The product comes with a double-sided mounting tape to affix the antenna outside of the mailbox, but it does not work well if it must be mounted to a rough surface of a wooden post. This mount can be screwed on securely on the post, then the antenna can be press-fit into the mount without glue or tape.

I printed it with matte PLA because it was being installed on a north-facing side which would not be directly exposed to the hot summer sun, but more heat-resistant material would be recommended depending on your application.

Note: I designed the screw hole to accept the screw that came with the product: ⌀3 hole with ⌀6x2 countersink.

Bambulabs

Bambu P1S

No

No

0.12

MakerWorld