• Put the rope through the hole.

• Tie a knob to adjust the needed length of the rope.

• put the rest of the robe into the handle.

• Close with the lid

Very simple handle for my kids skipping rope.
Check the parameters in the fusion file to adjust length, diameter etc to your needs.

As adding threads is always a pain, I opted in to simple rely on a very well tuned printer and have the outer diameter of the part of the lid which is put into the handle to be the same as inner diameter of the handle. This way you can just push the lid into the handle.

There is a parameter for a margin (currently set to 0) in the fusion file so you could change it to your needs. On option is to increase this margin and glue some felt on the outside of part of the lid you stick into the handle.