Makerbox Replicator 2X Duct Fan
Woody Skunk
Find Similar with AI
Print Profile(0)
Model File(0)
0
0
0
Published:2023-01-03 19:02:01
0
0
000Description
Model Source
Reviews(0)
Summary
Redesigned the filament Duct Fan to be able to print PLA.
No screws and no other special hardware needed.
The fan is not hitting the enclosure door as original design.
I used a Glue Gun the fan & holder and works very well
You can get yourself those special long hex screw if you are worried about not holding up.
Print it on the Side, tested on long term ,works great.
Print Settings
Printer Brand:
MakerBot
Printer:
MakerBot Replicator 2X
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
100
Notes:
You need to buy an extra 24v fan & cable extension and connect to motherboard FAN connector.
I used Left extruder fan connector to plug to bottom filament fan as I don't use both extruder at the same time for PLA prints (same me the cable extension).
for the above in Makerbot desktop , to activate the Left fan cooling (connected to the filament cooler), yo need to set the left extruder to use Hips at 200 degree or else wont enable the temperature cooling control (I suggest to use other better software).
Model Source
Original Link: View details
CC BY