a little cable winder for cabled earphones to carry around, it's designed with holes to fit the buds in so they stay protected inside your pocket, then there are guide slides to wind the cable over the holder, there is also a hole designed to fit (almost all) the phone jack in

supports are not needed, while it depends at most on how well your printer prints bridges btw

how to use it: my suggestion is to proceed this way: put your earphone's jack inside one of the side holes, then wind the cable around the holder and when you get to the end, put the buds inside the bigger holes

if the holes are way bigger than the buds and they fall out of them, just proceed in reverse: put your buds in the holes and wind the cable around the axis of the holder to ....hold them in place XD

then put the jack inside one of the side holes and you got it

using this holder depends a lot on how long and fit are your earphones cable and buds, everyone must find its own way!

tell me if you like this piece and your impressions and opinion about it!