Summary

This is my take on Kevpv floss command center. it is not technically a remix of his, but very very influenced by his.

this is made to take a full sized DJI air unit and use the stock antennas. the AU slips into the mount there is a hole for a zip tie to hold the AU in. the FPV camera mounts to the HD camera so they will always be in the same plane. the cameras are adjustable from 10-40*

there is a spot behind the AU mount to mount your RX

I also put the GPS mount flat so if you would like to use INAV you do not have to do custom magnetometer angle settings. there is a hole just under the GPS for a zip tie to secure the GPS.

you will need 2 3x10mm standoffs for the camera mount. plus 4 3x10mm screws. I suggest using a good washer on the upper camera mount screws to help spread the load. there are two holes in the base of the tower for zip ties to help stabilize the tower to the top plate.

the v5 tower is made to use a standard immortal T antenna

the v4 tower has a SMA mount for your RX antenna.

there is a hero9 and hero8 mount

this is backwards compatible any of Kevin's camera mounts. only difference is my mounts have "keys" that help them lock into the tower to keep them from slipping.

there is a xt60 and 35v 1000mf cap mount. if you have a 50v cap Kevin has a mount.

there is a mount for a self powered buzzer that mounts to the front two standoffs where the FPV camera would traditionally be mounted.

the tower, xt60 and buzzer mount can all be printed without supports on a well tuned machine. the camera mounts will require supports. I print the tower solid to the 100 layer (at .2mm layer height) so it is a little more stable to the bottom camera mount.

Kevin's command tower
https://www.thingiverse.com/thing:3704334