the 180 yarn minder 

Usefull for yarn wound on a cardboard cylinder.

Printing instructions

print 1 body and 2 needle stoppers.

No support needed, it can be printed in PLA or PETG

Assembly and use

Install a 3,5 mm (US 10) dpn. You will also need a swivel clasp with a wrist-band attached.

To use: thread the yarn through the eye, insert the skein between the prongs of the yarn minder, put the dpn through the prongs and the skein. Secure the dpn with the needle stoppers.

The cat-tail yarn minder

For yarn which requires about a 30 degree angle to wind smoothly.

Printing instructions

Print one,  You will also need a swivel clasp with a wrist-band attached.

No support needed, it can be printed in PLA or PETG

Assembly and use

To use: clip on the swivel clasp and pull the skein onto the cat's tail.  If needed, pull the yarn up to achieve a steeper angle.

The Angled Yarn Minder

For all smaller skeins. Winds smoothly at an angle.

Printing instructions

print one long or one short. You will also need a swivel clasp with a wrist-band attached.

No support needed, it can be printed in PLA or PETG

Assembly and use

To use: slide the skein onto the eye of the yarn minder and clip on the wrist-band. Knit or crochet from the ball, making sure it hangs freely when the yarn is pulled from it.

Please DO print these, sell these or remix them if you like!