2024-05-30 Updated threads from M20-1 to M20-1.5 . I Made the front of the base thicker for more threads as well.Check the pictures for basic instructions. Everything else is your choice. (top layer looks nicer with hilbert curve. I forgot to turn it on when I printed the final version)

My print settings for the stand:

0.2 layers.
3 walls.
10% cubic infill.
Normal auto supports on build plate only with 2mm spacing between support lines.
Seam: back
Recommended top layer pattern: hilbert curve.

Print settings for the base:

0.2 layers.
3 walls.
20% cubic infill.
No supports.
Seam: back

Print settings for the pins:

0.2 layers.
3 walls.
15% infill.
No supports.
Seam: back

Threaded pins are the same so there is no difference in which one you'll choose.

There is a hole at the bottom of both legs for m3 heat inserts. You will also need 2 x m3-10 screws (can be longer. Holes are 14mm deep). Threads on the pins are perfect. There are some hooks on the side for cable management as well (3mm wire).

My table is 26mm thick. If yours is the same or less you can try the stand. Threads on the pins are around 10mm . Height of the stand is around 180mm without base.