This bracket is designed to allow mouting rack mount equipment in a cupboard I was modifying. The brackets can be spaced to work with either 19in or 10in equipment.

I used a bracket at each end of the rack strip and attached it to the top and bottom of the cupboard , this is holding up fine with a pair of reasonably heavy 48 port POE switches and some other lighter eqipment and patch pannels however if mounting a smaller amount of lighter equipment then a single bracket for each side will likley work.

There are two versions avaliable, a double sided version with mounting holes on each side and a single sided version. If using the single sided version you will need to mirror it in your slicer to get the other facing if required.

The brackets are designed for use with the R0863/2MM rack strip from pen elcom which is avalible in various lengts (link to the 10u high version) however others are likley compatable as well.