A mounting plate for Raspberry Pi in the official case for Leviton structured media panels. I made this to hang Raspberry Pi in the wiring cabinet where the main ethernet switch lives.

Uses the Leviton push-lock pins, but you could use wood screws and a washer if the panel was mounted on plywood.

The RPi cases can be attached to this plate with ¼" #4 wood screws.

Fusion 360 file provided for modification. The file is parameterized to hopefully make it easier to change width and height if needed.

Print Settings

Printer: Ender 3 Pro w/ direct drive

Rafts: No

Supports: No

Resolution: 0.15-0.2mm

Infill: 15% or higher

Shells: 2+

Notes:

Doesn't need supports if printed flat with back on the build plate.