I ReMixed the OP's file (I hope he doesn't mind) so that I could print the stand on my Ender 3 Pro. The original file would not fit on my printer as many have stated.

I added small holes for dowels/screws to be glued into insted of just relying on gluing the three pieces straight to one another. I used small machine screws with an OD of 3.44mm cut down to fit into each hole and super glued them into one another. I did have to use a Dremel to open up the dowel/screw holes a bit but not much.

Hope this helps.

Custom Section

Category: Video Games