This is an adjustable shell for the Seleadlab Klipper Camera USB CAM 130° 2MP 1080P camera sold on Aliexpress (https://www.aliexpress.us/item/3256806655761594.html).

The enclosure is specifically designed for this camera. Three locating pins hold the camera in place while you snap on the cover.

Printing: I used paint-on supports for the two ends. Print 2 of these, as they are identical. Test fit of the snap-on rear cover before final assembly. If your lens doesn't fit make adjustments

Make sure you route the cable through the end support and the front cover before installing the rear cover. It's pretty obvious.

Install with M5 10mm button head screws.

Klipper: use Crowsnest with the following config:

[cam 1] mode: ustreamer port: 8080 device: /dev/video0 resolution: 1280x720 max_fps: 30 custom_flags: --format=YUYV

Performance: My Logitech C920 delivered reasonable frame rates but is big, has a poor field of view. I like the FOV of this camera a lot better. With MJPG I was getting 0-2 FPS. After changing to YUYV I'm getting much better frame rates of 10-12 at 1280x720 resolution.